• 11.jpg
  • 15.jpg
  • 3.jpg
  • 1.jpg
  • 7.jpg

RO Series

Models RO Series:

This catalogue describes RO SERIES COOLERS made of copper and steel.
Each data sheet provides the technical information about the heat exchanger used for cooling oil hydraulic system and about fans operated by electric or hydraulic motor.

Core’s technical specification 

  • material: copper and steel
  • Working pressure: 15 bar 
  • Test pressure: 22 bar 
  • Max working temperature: 120°C 

Please contact IRA for aggressive ambient 



The heat exchanger should be installed in such a way that there should be no obstacles to the air flow, respecting the minimum distance from the wall (1/2 fan diameter) so as to ensure a natural flow of cooling air. The cooler can be fitted in vertical and horizontal position. RO series coolers are normally used for cooling hydraulic circuits and installed on the return lines: they must be protected from impact and mechanical vibrations by support and must be connected to the circuit with flexible pipes. To prevent any damage caused by changes in flow, hammering and pulsations we recommend installing a by-pass valve.


  •  mineral oil

For other fluid consuls IRA RADIATORI

Cleaning oil side 
After having dismantled the exchanger, carry out the cleaning procedure by circulating de-greasing substance inside the radiator compatible with steel. Wash with hydraulic oil before reconnecting the cooler. 

Cleaning air side
Carry out this procedure using compressed air. Make sure that the direction of the jet is parallel to the fins so that they are not damaged. If the blockage of the exchanger is caused by build up of oil or grease, c1eaning can be carried out using a jet of steam or hot water. During c1eaning procedures the electric motor must be adequately protected.


During operation of heat exchangers observe following instructions:

  • Do not remove the fan grilles
  • Electrical connections must be made by skilled electricians in accordance with the attached electrical diagrams 
  • Exterior surfaces of heat exchangers may reach high temperatures so adequate guards must be installed or the unit must be mounted in an inaccessible position 
  • Do not perform work on the hydraulic motor until the hydraulic pipelines have been disconnected
Profile & Quality company

RAL Series
RO Series
RA Series
RC Series
GA Series
RF Series
RS Series
RP Series
VIA F.lli Bandiera, 8
44042 Cento (FE)

Tel:+39 051 014 74 06

Via F.lli Bandiera, 8 - 44042 Cento (FE)
CF e P.Iva 02002300388
N° iscrizione registro imprese e REA FE – 217409
Capitale sociale interamente versato 100.000 Euro
|Privacy Policy | Cookie Policy | © Copyrights 2017-19 • IRA Radiatori Engineering Srl - CF e P.Iva 02002300388